![]() Mix a 50/50 ratio of PVA glue and water in a small container. If your drill bit goes between the lath, use a pencil to mark that hole with an X. The masonry bit will go through the plaster and bump up against the lath. Simply incorporate the new sections into the repair. You may lose more plaster during this process, but that is normal. Using a 3/16″ masonry bit, drill holes, every 2-3 inches, approximately 1″ away from the crack on both sides and all the way around any missing chunks of plaster. I often use a shop vac and a scraper for this task. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |